Note: PV connection mode below is not allowed.
Step 2: DC Wiring
• Turn off the DC switch.
• Choose 12 AWG wire to connect the PV module.
• Trim 6mm of insulation from the wire end.
• Separate the DC connector as below.
• Insert striped cable into pin contact and ensure all conductor strands are captured in the pin contact.
• Crimp pin contact by using a crimping plier. Put the pin contact with striped cable into the corresponding
crimping pliers and crimp the contact.
• Insert pin contact through the cable nut to assemble into back of the male or female plug. When you feel or
hear a “click” the pin contact assembly is seated correctly.
• Unlock the DC connector
· Use the specified wrench tool.
· When separating the DC + connector, push the tool down from the top.
· When separating the DC - connector, push the tool down from the bottom.
· Separate the connectors by hand.
To Next Page
Loading...
