12
5.3 Mounting
- Installation Precaution
Make sure the installation location complies with the following conditions:
•
Not in direct sunlight.
•
Not in areas where highly flammable materials are stored.
•
Not in potential explosive areas.
•
Not in the cool air directly.
•
Not near the television antenna or antenna cable.
•
Not higher than altitude of about 4000m above sea level.
•
Not in environment of precipitation or humidity (>100%).
•
Under good ventilation condition.
•
The ambient temperature in the range of -30°C to +60°C.
•
The slope of the wall should be within ±5°.
• The wall hanging the hybrid inverter should meet conditions below：
1. Solid brick/concrete, or strength equivalent mounting surface;
2. Hybrid inverter must be supported or strengthened if the wall's strength isn't enough
(such as wooden wall, the wall covered by thick layer of decoration).
•
Avoid direct sunlight, rain exposure, snow laying up during installation and operation.
•
Space Requirement
•
Installation Steps
Tools required for installation include, but not limited to, the following recommended tools. If
necessary, use other auxiliary tools on the spot.
To Next Page
