15
2. Drill holes with a hammer drill (with a φ12 drill bit), clear holes, insert 4 PCS of expansion bolts
(by client, M10*95 is recommended) into holes, and fix them with a rubber hammer.
3. Fix the hanging plate with expansion bolts.
A: 4 PCS of M10 hexagon nuts B:4 PCS of expansion bolts (M10) C: Wall
Step 3: Inverter Installation
1. Lift the inverter from the package box with 4 PCS of screw-in type handles.
2. Install the inverter on the hanging plate, and ensure that lugs of the inverter are properly
matched with slots of the hanging plate.
To Next Page
