Foxpro Hammerjack - Transmitter Settings: AUX; Transmitter Settings: View; Transmitter Settings: About Info; Transmitter Settings: Cable Detect

14
8-15 Transmitter Settings: AUX
The auxiliary jack operation specifications can be changed from either momentary or latched. All FOXPRO
decoys require that the jack be setup for momentary. To configure the auxiliary jack setting, highlight the
“Aux Control” menu item, push the “Select” button, and then use “Sound Up” or “Sound Down” to toggle
the two options. When the appropriate setting is selected, push the “Select” button to lock it in.
IMPORTANT NOTE
Some third party decoys may require latched operation as opposed to momentary. A detailed list of
other products and their specific requirements is not maintained by FOXPRO. You will need to check
with the equipment manufacturer to determine if it is compatible and what the requirements are.
8-16 Transmitter Settings: View
The TX915 can display your sounds either by general listing or by category listing. Sound categories are the
best route to go if you have a large number of sounds. The TX915 supports up to 25 unique categories. To
configure the view setting, highlight the “View” menu item, push the “Select” button, and then use the
“Sound Up” or “Sound Down” buttons to cycle through the options. When the appropriate setting is
selected, push the “Select” button to lock it in. This setting is remembered between power cycles.
8-17 Transmitter Settings: About Info
The About Info screen displays a variety of information pertaining to version number, number of sounds
loaded, number of categories loaded, the number of presets, and transmitter health.
8-18 Transmitter Settings: Cable Detect
If cable detect is turned on, the transmitter will automatically prompt you to perform the download list
function when a 3.5mm stereo cable is connected to the sound upload jack. You can manually initiate the
download list process, if you prefer, by disabling this feature. This setting is remembered between power
cycles.
9. FOXCAST
This section provides you with detailed information on creating and installing FOXCAST sequence files in
your HammerJack.
Creating FOXCAST Sequence Files Manually
This process requires some basic computer operations experience. If you are not very experienced with
computers, it is recommended that you seek help prior to performing any of the following steps.
A FOXCAST sequence file is a simple text file that contains unique instructions to guide your HammerJack
through a stand. These instructions include commands to change the sound, change the volume level, enter
a passage of silence, and so forth. Here is a chart showing all of the available commands:
Instruction
Value
Description
S a [b]
a: 0 – 299
b: 1 - 100
Plays the sound (a) a total of (b) times.
V a
a: 0 – 20
Sets the desired volume level.
P a
a: 1 - 600
Denotes pause value in seconds (approx.)
M a
a: 1 – 1440
Denotes pause value in minutes.
W a [b]
a: 1 – 120
b: 2 - 120
Random pauses, in minutes, between values (a) and (b).