Foxpro X1 - Charging the X1; TX433 Requirements

7
2-3 Charging the X1
Your X1 game call comes with an 11.1V 5200mAh lithium ion battery pack and compatible charger. In order
to charge the battery pack, you will have to install the battery into the caller by following the steps in
Section 2-2 “Installing the Battery Pack in the X1.”
Once you have installed the battery, MAKE SURE THE CALLER IS TURNED OFF and any accessories (decoy,
external speaker, USB cable) are disconnected from the unit. You can now plug your charger into the
charge jack on the back of the caller and connect the other end to a 120V AC wall plug. At the end of the
charger, you will notice a glowing red light. This means the battery pack is charging. The light will turn
green once the battery is fully charged. It takes roughly 6 hours to charge a fully-depleted battery pack.
Note: There are some instances where the red light on the charger will slowly blink before turning solid
red. This is perfectly normal.
2-4 TX433 Requirements
The TX433 remote control operates on a single 9V battery (not included). It is recommended that you use a
high-quality lithium or alkaline battery for the best performance.
Installing a Battery in the TX433 Transmitter
1. Access the battery compartment by removing the battery compartment door from the
back of the TX433. The door slides down and off the remote.
GENERAL PRECAUTIONS FOR CHARGING
• Never attempt to charge batteries that are not intended to be recharged! This
includes both Zinc Carbon and alkaline cells. The resulting damage can be serious and
will not be covered by the warranty. For maximum charge efficiency, we recommend
charging your X1 in temperatures ranging from 40°F to 85°F (5°C to 30°C).
• Disconnect any/all accessory devices that may be attached to the X1 prior to charging.
This includes external speakers, auxiliary devices, and USB cables.
• Make sure that the power switch is in the “off” position while charging.
• Make sure that the rechargeable battery pack is installed in the X1 properly.
• Connect the approved FOXPRO charger to the charger jack on the X1 and attach the
transformer to the appropriate outlet.
• Do not leave charging batteries unattended.
• Remove battery pack from power wire when caller will not be used for prolonged
periods to help prevent deep discharge.
• Recharge your batteries periodically—even when not in use—to prevent deep
discharge.
WARNING
• Do not mix battery types! For example: never use NiMH rechargeable batteries in
conjunction with non-rechargeable alkaline batteries.
• Never connect your X1 to an unregulated 12V system (i.e. automotive systems, high
current power supplies, etc.) Serious damage will occur which is not covered by the
warranty. The charge jack is intended only for FOXPRO
®
chargers.
• Never attach an unapproved or a non-FOXPRO
®
charger to your X1! Damages caused
by plugging unapproved charging devices into your X1 will not be covered by the
warranty.