8
2. Insert the 9V battery in the back of the remote.
3. Slide the battery compartment door back onto the remote.
4. Push and hold the power button on the TX433 for approximately 1-2 seconds to power it
on. The LCD will activate and display the primary screen.
2-5 Playing Sounds
The primary function of your X1 game call is to produce sounds to attract wildlife. This section explains how
to turn on the X1 and the TX433 and how to start playing sounds.
1. Turn on the X1 by flipping the power switch to the “On” position. When powered on, the X1
pilot light illuminates green, indicating that it is powered on. If the light does not activate,
recharge your battery pack and try again.
2. Turn on the TX433 transmitter by pushing and holding the power button for approximately 1-2
seconds.
3. Notice the black horizontal highlight bar on the TX433 display. The bar moves up and down the
screen as you use the “Scroll Up” or “Scroll Down” arrow buttons.
4. Move the highlight bar to one of the sound categories and push the “Select” button. Doing this
results in displaying all of the sounds in that particular category. To exit the current category,
push the “Back/Menu” button.
5. After moving the highlight bar to the sound you wish to play, push the “Select” button a single
time to begin playback. Your selected sound will begin playing at low volume.
6. To adjust the volume: Use the “Volume Up” button to raise the volume level to your desired
setting. Use the “Volume Down” button to decrease the volume level. The transmitter has 20
volume steps.
7. To silence the sound: Push the “Mute” button a single time. When muted, the mute status
indicator on the TX433 display shows an “M” and the current sound is silenced. Un-muting is
accomplished by pushing the “Mute” button a second time (the “M” will no longer be displayed
and the sound will resume playing).
8. To switch sounds: Use the scroll buttons to navigate to a different sound and push the “Select”
button. You can switch sounds while the X1 is actively playing a sound or while muted.
9. To turn off the TX433: Push and hold the power button for approximately 1-2 seconds. Be aware
that turning off the remote control does not end sound playback on the X1. If you are finished
calling, use the “Mute” button to silence the X1 prior to turning off the TX433.
10. To turn off the X1: Flip the power switch to the “Off”(DOWN) position. The pilot LED will
extinguish.
2-6 Favorites
The TX433 allows you to establish a list consisting of 10 of your most frequently used sounds under the
“Favorites” menu. These “Favorites” allow for quick selection of your favorite sounds at your
predetermined volume level. This section describes the process involved in creating, changing, and using
your presets.
Creating New Favorites
1. Select the “Favorites” menu item on the TX433. If this is your first time working with favorites,
favorite 1 is automatically set to Coyote Pup Distress 3 at volume 10.
2. To set a preset, position the black highlight bar on one of the blank preset slots and push the
“Select” button a single time.
To Next Page
Loading...
