IX.Operation Guide
When the LED light flashes intermittently, it indicates specific diagnostic troubles referred in the
table below:
19
2. When the power is lower than 10% and the battery widget is red, the scooter won’t be
able to move as the power level is too low. The scooter will automatic shut down a few
minutes later.
1. If the battery widget displays a red colour, please charge as soon as possible, reduce the use
of driving function, change to the push model. If you fail to comply with this condition, you
may be unable to leave a potentially unsafe location like a road. The manufacturer will not be
liable for any incidents resulting with non-compliance of these instructions.
3. The LCD screen displays the current state of
charge. When you insert the charger, the LCD
display will show the battery is charging and the
battery widget will flicker. The scooter won’t
move.
4, When the battery is full, a sound will indicate
charging is completed every few minutes. The
battery widget will not flicker.
6. Right wheel failure
Controller unable to communicate with the right
wheel drive, or the right wheel have fault.
7. Overheating
Driver or controller internal temperature is too
high, may be due to failure preventing chair
from working normally.
5. Left wheel failure
Indicates controller is unable to communicate
with the right wheel drive, or the right wheel
fault.
Control Joystick
When operating the chair for the first
time, it is recommended to move the
chair at a low speed gently and gradually
pushing the control joystick forward. The
practice run will help you familiarize
yourself with controlling the speed and
start and stop of the chair.
Do not do sharp turns at high speeds. The
chair could lose its balance and tip over
causing serious bodily injury and property
damage.
The control joystick on the control panel
provides 360 degrees of comfortable and
effortless omnibearing maneuverability.
A spring is equipped inside the joystick
which automatically returns to its original
position when let go.
Push the joystick in the target direction.
The joystick can control the drive
proportionally, the harder the push, the
faster it goes. The max traveling speed is
6km/hr.
Release the control joystick slowly and
gradually for the chair to slow down
safely. Sudden release of the control
joystick may cause the chair to lose
balance and tip over causing bodily injury.
10. Joystick failure
Joystick is malfunctioning
9. Button failure
Button is malfunctioning
To Next Page
Loading...