FOXTR PL002 - Troubleshooting System and Charging

XIII.Troubleshooting
The fifth level LED light flashes:
Push the electromagnetic brake lever
The electromagnetic brake is in
to “Drive” position, please refer to
“Free wheel” Position and the chair
instructions on Page 20
will not move
When the power is off, and the
3
Electromagnetic
electromagnetic brake lever is in
Contact the customer service to
brake
“Drive” position, the motor wheels
replace the electromagnetic brake.
can move freely.
When the power is on, and the
electromagnetic brake lever is in
Contact the customer service to
“Drive” position, the motor wheels
replace the electromagnetic brake.
cannot move.
When the power is off, and the
electromagnetic brake lever is in
Contact the customer service to
“Free wheel” position, the motor
replace the electromagnetic brake.
wheels cannot move.
4
Motor Wheels
Noisy and vibration occurs in the
Contact customer service
course of motor run.
5
Distance per
charge decreased
Low temperature environment
It is normal as lithium batteries
functioning below 0C will see range
decrease
Battery use has exceeded its
Contact customer service to replace
service life.
the battery.
Faulty connection of the control
Reconnect the 4 – pin plug into the
6
Charging
battery connector at the side of the
panel and the battery connector
chair.
Control Panel damage.
Contact customer service to replace
controller.
Charger plug damaged.
Contact customer service to replace
charger.
Charging plug loosened.
Reconnect firmly.
7
Fail to start
After not using for a period or
Turn the power on and off. To
when power on
after charging.
reactivate
31