Foxwell NT301 - Diag Beep Set

NT301 OBDII/EOBD Code Reader User’s Guide_English Version_V1.00
40
Key beep set opens a dialog box that allows you to turn on/off the built-in speaker for key
pressing.
To set the key beep:
1. Use the UP/DOWN key to highlight Key beep set from Setup menu and press the ENTER key.
Figure 7-14 Sample Setup Screen
2. Press the UP/DOWN arrow key select an item and press the ENTER key to save and return.
Figure 7-15 Sample Beep Set Selection Screen
7.5 Diag Beep Set
Key beep set opens a dialog box that allows you to turn on/off the built-in speaker when
performing diagnostics.
To set the diag beep:
1. Use the UP/DOWN key to highlight Key Beep Set from Setup menu and press the ENTER key.
Figure 7-16 Sample Setup Screen
2. Press the UP/DOWN key to select an item and press the ENTER key to save and return.