76
Smart Diagnostic & TPMS Scanner TS7000 User's Manual V1.0
Figure 11-17 Sample OBD Learn Help Screen
To perform OBD Relearn
1. Install the tire pressure sensor correctly.
2. Inflate all the tires to the rated value in the nameplate(usually on the door
or door frame).
3. Using the TPMS tool, activate each sensor.
4. Turn on the ignition on (to ON/RUN/START).
5. Connect the TPMS tool to the OBDII interface, and use OBD relearn
function to write the sensor ID.
6. Keep the ignition switch on (ON/RUN/START) and reactivate each sensor
in turn.
7. Turn off and then turn on the ignition on.
8. Drive the vehicle at a speed of not less than 30 km/h for at least 10
minutes, to ensure that the tire pressure system works normally (the tire
pressure light is off).
NOTE:
Different models have different OBD relearn methods. Please read the
relearn procedure carefully before performing the relearn function.
11.3.2 Automatic Relearn
To Next Page
Loading...
