77
Smart Diagnostic & TPMS Scanner TS7000 User's Manual V1.0
Figure 11-18 Sample Automatic Relearn Help Screen
To perform Automatic Relearn
1. Install the tire pressure sensor correctly.
2. Park for at least 15 minutes.
3. Inflate all the tires to the rated value in the nameplate(usually on the door
or door frame).
4. Turn on the ignition on ( to ON/RUN/START).
5. Operate the instrument panel to let the vehicle enter the automatic relearn
mode (if need).
6. Drive the vehicle at a speed of 30-100 km/h for at least 15 minutes, to
ensure that the tire pressure system works normally (the tire pressure light
is off).
NOTE:
Different models have different Automatic relearn methods. Please read the
relearn procedure carefully before performing the relearn function.
11.3.3 Static Relearn
To Next Page
Loading...
