10
Engine speed and accessory functions control
Programming of the functions here following is possible commuting
the position of the JP switches.
JP1: Engine speed selection
1-2 = 1,800 rev. /min (60 Hz power generation)
2-3 = 1,500 rev. /min (50 Hz power generation)
JP2: Mode selection
1-2 = DIAGNOSIS MODE
2-3 = OPERATING MODE
JP3: Pre-heating warning light
1-2 = connected
2-3 = not connected
JP4: Fuel pre-heating
1-2 = relay on
2-3 = relay off
JP5: It CAN line
1-2 = available
2-3 = unavailable
BP1: Blink code request switch button
LD1: Blink code display
FOR PROPER USE OF THE ENGINE
Before starting the engine, check there is enough fuel in the fuel
tank.
Do not keep on starting.
Do not keep the engine idling for a long while since this has
negative effects to the engine performance.
Actual power values must comply with the rated values reported
in the technical documentation.
When operating the engine, regularly check that:
- the cooling liquid temperature does not exceed the threshold
value;
- the oil pressure keeps within normal values.
Particular attention must be drawn on emergency power unit
engines, which must be submitted to frequent overhauls in order
to ensure their prompt start whenever required.
WARNING
Pay attention to the board panel instrument readings and indications.
To Next Page
Loading...
