30
UNSCHEDULED MAINTENANCE - HOW TO
PROCEED
Change the auxiliary device belt
Only proceed when the engine is not turning and is at low
temperature so as not to run the risk of burns.
Remove the protective grilles and the fan together with the spacer
by undoing the relative fasteners.
Act on the automatic belt tensioner (1) and remove the auxiliary
device drive belt (6).
Act on the automatic belt tensioner (1) and force fit the new
auxiliary device drive belt (6).
Check that the belt (6) is inserted correctly inside the alternator
pulley (2); also check that the water pump pulley (3), the crankshaft
pulley with damper (4), the guide pulley (5) and the fan pulley (7)
are inserted correctly.
Fully rotate the crankshaft twice to ensure that the new auxiliary
device drive belt (6) has been correctly fitted.
Reposition the fan, together with spacer, in its seat and the
protective grilles and tighten the relative fasteners.
Do not use detergents or diesel to clean the air filter.
Never strike the filter element with tools.
The imprecise assembly of the air filter may result in
the intake of unfiltered air and therefore cause serious
damage to the engine.
To Next Page
Loading...
