Franke COMPACT T 400 - Page 14

12
11-03-2014 / LSC 178 / Rev. 00
400
T
• Betweenthewatermainsandthewaterinletpipeoftheappliance,theremustbeataptostopthewaterflowifnecessary(2-Pict.7).
• Watermainspressuremustbewithintherangeof1 and 6 bar.
If this requirement is not met, please consult the manufacturer.
• Theapplianceissuppliedwithoutaplug.Itissupposedtobedirectlyconnectedtothepowersupplyandtherefore,itisnecessary
to fit a multi-pole power switch with a switch-contact gap of at least 3mm or more beforehand, according to the regulations in force
(1 - Pict.7).
• The drain pipe of the appliance must be directly connected to a suitable open drain siphon, previously installed by the customer (3 - Pict.7).
Do not fit the drain pipe into basins or buckets placed under the counter as this will increase the possibility of forming dirt deposits
and as a result, the spread of bacteria.
Attention!
The appliance is supplied without water in the boiler. This is to prevent serious damage if the appliance is exposed to low
temperatures. The appliance must only be supplied with cold drinking water.