400
T
Every 3 days
After turning off the machine, remove the shower heads using the wrench provided;
brush them carefully, making sure that all the holes are clean. Then reassemble the
parts following the sequence shown in the picture 17.
A. Fastening screw
B. Small shower head
C. Large shower head
D. Diffuser
E. Delivery group
E
D
B
C
A
Fig. 17
Take note!
Do not use water jets to clean the machine.
Attention!
At the end of each workday and after performing the daily cleaning operations, deactivate the machine by closing the electrical system
switch and the water mains tap (pict. 7 – page 11).
WATER SOFTENER
If the installation of a water softener has been recommended by the installation engineer because of hard water and problems of scale
deposits, it is necessary to follow the instructions of the water softener’s manufacturer (periodic regeneration).
MACHINE BODY
Clean the body of the machine using mild detergents to avoid any damage.
We recommend not to use abrasive sponges that could damage the body panels.
To Next Page
Loading...
