Franke DC 2200 - PROGRAMMING

8
5.0 PROGRAMMING
1. Press buttons
0
and
3
for 5 sec’s. Release button 3 first and then
button 0. F/I appears on display.
2. Select the program button to be reprogrammed.
3. Select fan speed by buttons
+
and
-
: 1 (only one speed available),
(if 0 selected, the function of button ignored) Confirm settings by
pressing the button
0
.
Temperature selection C.
When selecting the drying temperature (range 20-90
0
C) use buttons
+
and
-
, and confirm by pressing the
0
. (See picture; program 1,
55
0
C)
Drying time selection t.
When selecting the drying time (range 10-99 min) use buttons
+
and
-
. Confirm setting by pressing the button
0
. (See picture;
program 1, 10 min)
4. After restoring the last program phase you can start to program
any program button you want.
Press the button
0
to get into operating mode and temperature will
appear on display.
** Error on the programming procedure:
Switch off the main power and start the programming from the
beginning (or restore the program to be changed by 0 button and
reprogram the button.)
F
I
C
5
I
5
F
I
I
t
0
I
I