23
COOKING ADVICE
PAN QUALITY
Accepted materials: steel, enamelled steel, cast iron, ferromagnetic stainless-steel, aluminium with
ferromagnetic bottom.
Not accepted materials: aluminium and stainless-steel without ferromagnetic bottom, copper, brass, glass,
ceramic, porcelain.
The manufacturers specify if their products are compatible induction.
To check if pans are compatible :
• Put a little water in a pan placed on an induction heating zone set at level [ 9 ].This water must
heat in a few seconds.
• A magnet sticks on the bottom of the pan.
Certain pans can make noise when they are placed on an induction cooking zone. This noise doesn’t mean any
failure on the appliance and doesn’t influence the cooking operating.
PAN DIMENSION
The cooking zones are, up to a certain limit, automatically adapted to the diameter of the pan. However the bottom
of this pan must have a minimum of diameter according to the corresponding cooking zone.
To obtain the best efficiency of your hob, please place the pan in the centre of the cooking zone.
To Next Page
Loading...
Need help?
General
