27
ELECTRICAL CONNECTION
GAS CONNECTION
• The installation of this appliance and the connection to the electrical network should be entrusted only to an
electrician following the normal regulations.
• Protection against the parts under tension must be ensured after the building-in.
• The information on connections necessary are on the stickers. Place them on the hob casing near the connection box.
• Connection to the mains must be made using an earthed plug, which must be accessible after installation, or via an
omnipolar circuit breaking device with a contact opening of at least 3 mm.
• The electrical circuit must be separated from the network by adapted devices, for example: circuit breakers, fuses or
contactors.
• If the appliance is not fitted with an accessible plug, a disconnecting means must be incorporated in the fixed
installation, in accordance with the installation regulations.
• The inlet hose must be positioned so that it does not touch any of the hot parts of the hob or oven.
This appliance must only be connected to a 230V ~ 50/60Hz. Network.
An appliance suitable for gas connection must only be installed by an authorised person.
The installation must comply with these instructions, any local regulations and the requirements of AS/NZ 5601.
GENERAL INFORMATION
• The gas connection is ½ in copper compression mounted horizontally facing the rear of the appliance,
the connection point is 300mm from the left-hand side of the cut out and 100mm back from the front edge
of cut out.
• Where fitted the regulator must be located so that it is accessible after installation.
• This appliance is not intended for us by children or persons with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• IF YOU SMELL GAS - Open windows and doors and extinguish any open flame. Do not touch electrical switches and
call your gas supplier immediately.
SAFETY WHEN IN USE
• Remember this appliance produces heat and therefore will get hot. Let pan supports and other surfaces cool down
before touching them.
• Do not leave children unattended near the appliance when it is hot or in use.
• Do not store or use petrol or other flammable vapours or liquids in the vicinity of this or any other gas appliance.
MODEL TOTAL POWER INDUCTION ZONES SIZE NOMINAL POWER BOOST MIN. PAN SIZE
HT1C604B1/
FIXG9041B1
7400W 4 220/180mm 2100W 3700W 100mm
To Next Page
Loading...
Need help?
General
