Franke HCMF-30P - Shelf Rail Adjustment

1219011739 - Rev. A - November 30, 2018
OPERATION
2. Loosen three (3) screws fastening each middle
shelf rail to interior freezer wall. Slide rail forward
(Fig. 24) and then away from wall to release from
screws (Fig. 25).
Fig. 24
Fig. 25
3. Reinstall rails by placing keyholes at intended
shelf height on screws in freezer wall (Fig. 26).
Slide rails back, then tighten screws to fasten rail
in place (Fig. 27).
Fig. 26
Fig. 27
4. Once wire shelf is dry, place back onto shelf rails
(Fig. 28).
Fig. 28