Electrical connection
Important
- All maintenance and adjustment work on the appliance must be performed
with the power disconnected.
- The connection must be made in accordance with current regulations.
- The connection must be made only by a specialist authorised electrician.
- The appliance operates correctly with alternating current at 220/240 V~
single-phase 50 Hz.
- THE APPLIANCE MUST BE EARTHED. If the appliance is connected
directly to the mains, an omnipole switch must be fitted sized for the load of
the appliance with contact opening of at least 3 mm and in compliance with
current regulations.
- The earth cable must not be interrupted by the switch.
ALL MAINTENANCE AND ADJUSTMENT WORK ON THE
APPLIANCE MUST BE PERFORMED WITH THE POWER
DISCONNECTED.
-The appliance is provided with electrical cable without plug; it must be
connected to a plug sized for the load of the appliance, remembering that the
yellow-green cable must be connected to the plug earth connection. The
connection plug must be sized for the load of the appliance.
- After the connection, test the heating elements and operate them for approx.
5 minutes to remove the ambient humidity absorbed.
- The manufacturer accepts no civil or criminal liability if the connection is
not made in compliance with current regulations.
To Next Page
Loading...
