3-in-1 tap
Avoid burns and scalding and pay attention when
using hot water. The temperature of the hot water
may be higher than 55°C.
Avoid burns and scalding and pay attention when
using boiling water. The temperature of the water
may be higher than 100°C.
Tiled and stone sinks will not withstand boiling
water; the difference in temperature can cause
these to crack. Always open the cold water tap
when pouring out boiling water and preferably
pour the boiling water directly into the drain.
Boiler
Before commissioning, ensure that the boiler is
filled with water.
Never pick up or carry the boiler with the hoses or
the mains lead.
M Box
The appliance is not intended for connection to
the hot water supply (hot-fill).
The drain hose must be connected with a
steady down gradient in order to ensure the
correct function of the siphon in the M-Box. The
connection point of the drain hose should be
downline of the sink siphon.
Filter cartridge
The use of a water filter is mandatory to protect
the product against lime scale deposits.
After storage at a temperature of 0°C, the
filter must first be stored for 24 hours at room
temperature before it is installed.
The filter cartridge must not be opened or
damaged.
The filter cartridge and the system must be
intensively flushed after a prolonged standstill
period and/or during maintenance work (2 litres
of flushing water after 1 week standstill; 10 litres
of flushing water after 4 weeks’ standstill).
The filter cartridge must be replaced if, after
commissioning, it has not been in operation for 3
months.
Water quality requirements
pH value
7 – 9.5
Iron content (Fe)
< 0.2 mg/l
Chlorine content (Cl)
< 150 mg/l
Conductivity
< 125 mS/m
Chemical additions
Not permitted
Installation instructions
NEVER use serrated tools in order to avoid
damage. Where necessary, always use the
appropriate tools for tightening the coupling.
Minimum bending radius after installation
∅
min.
∅
min :
DN 6 =
∅
50 mm
DN 8 =
∅
60 mm
DN10 =
∅
70 mm
DN13 =
∅
90 mm
min. 2
∅
e
Without bends after installation
Without bend immediately after connection
Without tension after installation
Without torsion after installation
To Next Page
Loading...
Need help?
General
