Boiler ECO mode
Switch on ECO mode:
- Hold depressed for 4 seconds, LED is green.
Switch off ECO mode:
- Hold depressed for 10 seconds, LED is not
green.
4E
4D
When the boiler is switched on, the temperature
of the water is automatically held constant so that
boiling water is available at any time of the day. In
order to prevent the temperature of the boiler being
unnecessarily held constant, you can use the energy-
saving ECO mode. After activation, ECO mode comes
into operation every day at the same time. The
duration of ECO mode is 6 hours and the LED should
light up green during this time.
If using a Switch, the setting of the ECO mode should
be cancelled when the boiler is switched off. ECO
mode then has to be set again.
Note: Before commissioning the boiler, see
"Flushing".
Switching off the boiler
5 litre boiler:
Press the ON/OFF knob; the LED lights up white
(fig 4D).
Remove the plug from the plug socket.
10 litre boiler:
Turn the ON/OFF knob to the „○” position
(fig 4E).
Remove the plug from the plug socket.
Emptying boiler
9 Remove the plug of the boiler from the wall plug
socket.
9 Turn on the boiling water tap.
9 Wait until cold water runs out.
9 Turn off the boiling water tap.
9 Close the stop valve.
9 Turn on the boiling water tap.
9 Wait until water no longer runs out.
9 Turn off the boiling water tap.
9 Disconnect the lines from the boiler.
Remove the boiler.
Allow the water from the hoses and the boiler to
drain into the sink.
To Next Page
Loading...
Need help?
General
