Franke SD3200 - User Manual

To Next Page

MAINTENANCE

1. With normal use, maintenance should not be necessary.

Should there be an extended period where the dispenser

isn’t used, it is possible the soap/lotion could harden

and clog the dispenser. In this event, submerge the entire

dispensing head with pump into hot water for several

minutes. Next pump hot water through the assembly.

Repeat as necessary to remove the clog.

2. To clean the dispenser, use a soft cloth or sponge with

soap and water only. Do not use any abrasive cleaners or

pads.

Dry with a cloth or paper towel.

3. Replacement Parts

1 - Pump SD 3101

2 - Bottle SD 3102

3 - Fill Tube SD 3103

COD. 340V0020A7

INSTALLATION GUIDE

Soap dispenser: SD3200, SD3201, SD3202, SD3203,

SD3204, SD3205, SD3206, SD3207, SD3220, SD3222,

SD3240, SD3261, SD3265, SD3270, SD3280, SD3290

KSD5500, KSD5501, KSD5502, KSD5503,

KSD5505, KSD5507, KSD5550

PRODUCT WARRANTY

Congratulations on the purchase of this Franke product!

Franke is one of the world’s largest manufacturers of

kitchen systems. Our products are manufactured using

the highest degree of technology, quality, and design.

As a result, we are proud to offer the following warranty.

Franke warrants the quality of its soap/lotion dispensers

to be free from manufacturing defects for a period of ﬁve

years from the date of purchase.

This warranty applies only to the original owner, providing

the product has been installed in accordance with these

installation instructions, used as recommended, and in

normal residential application. In the event of a warranty

claim, the owner will be required to provide proof of

purchase - SAVE ORIGINAL SALES RECEIPT!

This warranty covers all components which make the

product operational. Franke reserves the right to inspect

the installation prior to the replacement of the product or

component part.

This warranty does not cover misuse or abuse, accidental

damage, scuffs, or scratches, abnormal usage, negligence

or damage caused by improper maintenance or cleaning.

Normal wear of parts is excluded from the warranty.

Damage caused by impurities or acts beyond Franke’s

control are not covered. Any product or part which has

been repaired or altered in any manner outside of Franke’s

factory, unless previously authorized in writing by Franke,

will void the warranty.

Any replacement excludes transportation and any labor

reinstallation costs. This warranty doesn’t allow recovery

of incidental or consequential damages such as loss of

use, delay, property damage, or other consequential

damage, and Franke accepts no liability for such damages

The Franke warranty is limited to the above conditions and

to the warranty period speciﬁed herein and is exclusive.

Franke DISCLAIMS all other warranties, expressed or

implied, including the IMPLIED WARRANTIES OF

MERCHANTABILITY AND/OR FITNESS FOR A PARTICULAR

PURPOSE. This warranty gives you speciﬁc legal rights

which may vary from state to state.

Further Information

For any further information about Franke products, about

the installation of them, or about the guarantee, please

contact our Customer Service Department:

Franke Kitchen Systems, LLC

800 Aviation Parkway

Smyrna, TN 37167

Phone: 1-800-626-5771

Fax: 1-888-685-0007

www.franke.us/ks

In Canada:

Franke Kindred Canada Limited

1000 Franke Kindred Road

Midland, Ontario L4R4K9

1-866-687-7465

info@kindred-sinkware.com

Need help?

Do you have a question about the Franke SD3200 and is the answer not in the manual?

This document describes the Franke soap/lotion dispenser, a device designed for dispensing soap or lotion in residential kitchen systems. Franke, a leading manufacturer in kitchen systems, emphasizes the high degree of technology, quality, and design in its products.

Function Description:

The Franke soap/lotion dispenser is a countertop-mounted device that provides a convenient way to dispense liquid soap or lotion. It consists of a dispensing head, a pump mechanism, a fill tube, a base assembly, and a bottle. The dispensing head is positioned above the counter, while the bottle and the majority of the assembly are located beneath it. Users fill the bottle with their preferred soap or lotion, and by pressing the dispensing head, the pump mechanism draws the liquid up through the fill tube and dispenses it.

Important Technical Specifications:

The document lists several model numbers for soap dispensers, indicating a range of available options. These include:

SD3200, SD3201, SD3202, SD3203, SD3204, SD3205, SD3206, SD3207, SD3220, SD3222, SD3240, SD3261, SD3265, SD3270, SD3280, SD3290
KSD5500, KSD5501, KSD5502, KSD5503, KSD5505, KSD5507, KSD5550

The installation requires cutting a 1-1/8" hole in the mounting surface. The bottle has a capacity of 300 ml, as indicated by the "300 ml" marking on the bottle in the diagram.

Usage Features:

Easy Refill: The dispenser is designed for top-fill, meaning the bottle can be refilled with soap or lotion from above the counter without needing to remove the bottle from underneath. This is achieved by inserting the fill tube into the base assembly.
Clog Prevention Tip: To minimize clogging, especially with thicker liquids, the manual suggests filling the bottle with 1/3 water and 2/3 soap, then mixing well using the fill tube. This dilutes the soap slightly, making it less prone to hardening and clogging the pump mechanism.
Simple Operation: Once installed and filled, the dispenser operates by simply pumping the dispensing head several times until the soap or lotion is discharged.

Maintenance Features:

Routine Maintenance: Under normal use, the dispenser generally requires no specific maintenance.
Addressing Clogs: If the dispenser is unused for an extended period, soap or lotion can harden and clog the mechanism. To resolve this, the entire dispensing head with the pump should be submerged in hot water for several minutes. Afterward, hot water should be pumped through the assembly repeatedly until the clog is cleared.
Cleaning: For general cleaning of the dispenser's exterior, only a soft cloth or sponge with soap and water should be used. Abrasive cleaners or pads are explicitly prohibited to prevent damage to the finish. After cleaning, the dispenser should be dried with a cloth or paper towel.
Replacement Parts: The manual provides a list of replacement parts, indicating that individual components can be replaced if needed:
- Pump: SD 3101
- Bottle: SD 3102
- Fill Tube: SD 3103 This modular design allows for easier repair and extends the lifespan of the dispenser.

Warranty Information:

Franke offers a five-year warranty against manufacturing defects from the date of purchase. This warranty applies only to the original owner and requires proof of purchase (original sales receipt). It covers all operational components, but Franke reserves the right to inspect the installation. The warranty does not cover misuse, abuse, accidental damage, scuffs, scratches, abnormal usage, negligence, improper maintenance, cleaning, or normal wear. Damage from impurities or acts beyond Franke's control, or repairs/alterations not authorized by Franke, will void the warranty. The warranty excludes transportation and labor costs for replacements and does not cover incidental or consequential damages. Franke explicitly disclaims all other express or implied warranties, including merchantability and fitness for a particular purpose, except as stated.

Installation Instructions Summary:

Unpack and check all contents.
Cut a 1-1/8" hole in the mounting surface if not already present.
Connect the fill tube to the pump in the dispensing head.
Unscrew the connecting sleeve and mounting nut from the base assembly shank.
Insert the base assembly into the hole.
Screw the mounting nut and connecting sleeve onto the base assembly shank.
Screw the bottle into the connecting sleeve.
Fill the bottle with soap or lotion (consider the dilution tip).
Insert the dispensing head with the fill tube into the base assembly.
Pump the dispensing head until soap/lotion is discharged.

For further information or assistance, customers can contact Franke Kitchen Systems, LLC in the USA or Franke Kindred Canada Limited in Canada, with provided phone numbers, fax, website, and email addresses.