Franklin Electric C1 SERIES - User Manual

OWNER’S MANUAL
C1-SERIES CISTERN
BEFORE YOU START
BEFORE INSTALLING PUMP, BE SURE TO READ THIS
OWNER’S MANUAL CAREFULLY.
REFER TO PRODUCT DATA PLATE(S) FOR ADDITIONAL
OPERATING INSTRUCTIONS AND SPECIFICATIONS.
• Keep work area clean, well-lit and uncluttered.
• Keep safety labels clean and in good condition.
• Wear safety glasses while installing or performing
maintenance on pump.
• Adhere to the guidelines of the National Electric Code (NEC)
or Canadian Electric Code (CEC), and any other state and local
codes for ALL electrical installations. Check with the
appropriate agencies or contact a licensed electrician.
• Most water system problems result from improper installation.
It is suggested that you read this manual carefully
before installing your pump.
• Check and make available all the tools you will need to
install your pump. Required tooling may include wrenches,
pipe sealant, pipe ttings and nipples, screwdriver, etc.
Be sure to have available proper and adequate wiring material
to complete the installation correctly.
READ AND FOLLOW SAFETY INSTRUCTIONS
This is the safety alert symbol. When you see
this symbol on your pump or in the manual, look
for one of the following signal words and be alert
to the potential for personal injury:
warns about hazards that will cause
serious personal injury, death or major
property damage if ignored.
CAUTION
DANGER
warns about hazards that can cause
serious personal injury, death or major
property damage if ignored.
warns about hazards that will or can
cause minor personal injury or major
property damage if ignored.
The label NOTICE indicates special instructions, which are
important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
HAZARDOUS PRESSURE. Do not run pump
against closed discharge. Release all system
pressure before working on any component.
Under certain conditions, submersible pumps
can develop extremely high pressure. Install
a pressure relief valve, which is capable
of draining the pumps max output at the
relief valves rated pressure.
Do not run pump dry. Pump must be fully submersed in water
prior to starting. If run without water, the pump and motor will
be damaged.
Electrical Safety
Make sure all ELECTRICAL POWER IS OFF
before connecting any electrical wires.
CAUTION
WARNING
WARNING
CAUTION
WARNING
WARNING

Summary

Before You Start

Read and Follow Safety Instructions

General Safety

C1-Series Key Features

Inspect Your Shipment

Installation

Location Of The C1-Series Pump

Specifies the pump's intended installation environment, emphasizing protection from freezing.

Notice: Read and Follow All Instructions!

Highlights the importance of following all installation guidelines, including electrical and plumbing codes.

Electrical Installation

Plumbing, Piping, And Hoses

Flow Capacity By Pipe Size

Provides guidance on selecting pipe diameter based on water velocity and flow rate.

Water Supply Requirement

Horizontal Offset Suction Piping

Explains how suction piping diameter affects friction loss and system performance.

Pump Installation Procedure

Operation

Priming

Details the process of priming the pump, emphasizing full submersion before starting.

Starting

Explains how to start the pump and open the discharge valve gradually.

Process To Ensure Pump Is Receiving Enough Water To Meet Demand

Outlines steps to adjust the discharge valve for optimal flow and prevent cavitation.

Lubrication

States that the pump requires only water for lubrication and should never run dry.

Installation Records

Limited Warranty*

Franklin Electric C1 SERIES Specifications

General

Brand	Franklin Electric
Model	C1 SERIES
Category	Water Pump
Language	English