It is strictly forbidden to install, maintain or handle RC65 or RM65 units
outdoors during bad weather such as thunder, rain, snow and high winds.
It is strictly forbidden to work on or operate the RC65 or RM65 equipment
alone. For safety, make sure that there is someone around you who can help.
When installing and maintaining the RC65 or RM65 equipment, avoid any
foreign objects being inserted or dropped into the enclosure.
To prevent misoperation, ensure that the upstream and downstream switches
are disconnected and padlocked during installation or maintenance.
During the transport and handling of RC65 or RM65 units, extreme care is
required to avoid dropping, bumping, stomping, or inverting the equipment.
Only use parts or accessories purchased from FranklinWH or a FranklinWH-
certified party.
Do not paint any part of RC65 and RM65 equipment unless the paint surface of
the equipment housing is accidentally damaged during transport, installation or
maintenance. The damaged part can be repaired with paint or topcoat of the
same color.
If any equipment failure occurs, please contact your installer or after-sales service
provider for support. Do not attempt to take apart, repair and/or modify RC65 or
RM65 without the authorization of FranklinWH. Otherwise, it may lead to safety
hazards and void your warranty.
Do not use the RC65 or RM65 if there is functional or cosmetic damage noticed
after unboxing (except for slight paint damage). Contact after-sales service for
support.
The installation, wiring, maintenance, transportation, and handling of RC65 and
RM65 units should follow local laws, regulations and standards, and the Safety
Instructions in this Guide serve as supplementation to the laws, regulations and
standards.
To Next Page
Loading...