Need help?Do you have a question about the Frascold R-TSL1 100 360 Y and is the answer not in the manual?
General| Model | R-TSL1 100 360 Y |
|---|---|
| Type | Semi-Hermetic |
| Oil pump | Yes |
| Refrigerant | R404A |
| Voltage | 380-415V, 3Ph, 50Hz |
Describes the integral protection system, including PTC thermistors.
Explains the oil injection lubrication system and its function.
Information on lubricant type, viscosity, and quantity for R-TS compressors.
Warning about the impact of frequent stop/start cycles on compressor lifespan.
Lists operational limits for current, voltage, pressure, and cycle frequency.
Procedures to verify compressor integrity and component completeness.
Details on fixing the compressor to a horizontal base with vibration absorbers.
Instructions for making refrigerant connections, emphasizing cleanliness.
Guidelines for electrical connections, safety, and wiring diagrams.
Explains the external oil circuit for lubricant separation and return.
Details the essential role and requirements of the oil separator.
Explains the PWS starting method, its advantages, and wiring.
Instructions for charging lubricant into the oil separator.
Steps for evacuating the refrigeration circuit to remove air and moisture.
Procedure to perform a vacuum leak test after evacuation.
Instructions for charging refrigerant into the system, including safety notes.
Guidance on using electronic leak detectors for finding refrigerant leaks.
How to measure supply voltage and check for voltage drop.
Procedure for checking voltage balance between phases for PWS and DOL.
Final checks after starting, including pressure difference and oil flow.
Highlights the function of the high pressure switch for compressor protection.
Lists required maintenance interventions based on operating hours.
Procedure for replacing compressor lubricant, emphasizing hygiene.
Electrical wiring diagrams for compressor starting and control circuits.
To Next Page
