WLA200 Rev140407
11
Apply sealent around
base and threads.
Thin Wall Adapter
Figure 3. Pressure Sensor
Apply epoxy around
ange, threads, and
screws.
Apply sealent
around base and
threads of sensor.
Typical Pressure
Sensor Location
Typical
Tank
1/2 NPS
2"
Mount sensor approximately
2" from bottom of tank.
Note: The sensor can be mounted
vertically on a 90° tting in cold areas to
help prevent water freezing in the sensor.
0.6"
7/8"
Across Flats
1/4 NPT
2.8"
(max)
1.1"
3-Pin
Packard Plug
0.87"
Note: Do not mount the sensor in the
bottom of the tank. Sediment may collect
in the port and cause sensor failure.
To Next Page
Loading...