WLA200 Rev140407
16
Install Remote Light Driver
The remote light driver is water proof to allow for exibility in the mounting
location.
1. Measure and mark mounting location for light driver. Make sure there is
clearance for driver and cable before drilling holes. Refer to Figure 5 for
dimensions.
2. Drill and tap two 10-32 holes.
3. Secure remote light driver with two screws.
4. Connect cable and wires. (Refer to Wiring section.)
Install Buzzer
Install the buzzer close to the TankVision so the audible warning is easily associated
with the TankVision. A cutout hole diameter of 1-1/4" is required. ( Refer to the wiring
section.)
Figure 6. Remote Light Driver
2 3/4"
1 3/8"
3 1/2"
4"
1"
To Next Page
Loading...