Freelap Stopwatch - Training; Stopwatch Mode

• • 
• STOPWATCHMODE
-START
SwitchtoTIMING(CHR)bypressingtheMODEbuttononce(youmust
be in TIME mode).
The stopwatch then displays how many laps can be stored before the
memory is full. Following this the stopwatch will go into timing mode. The
displaywillthenstartashingwhichmeansitisreadytostart.
The stopwatch can start automatically:
• byleavingthetransmittereld
• bypassingthersttransmitter(yingstart)
• by activating the starting gate Tx Gate (alpin skiing)
• by activating the Tx Touch transmitter (athletics)
-LAP
At each transmitter, the LAP time remains on the
screen (to hold the time see section 2 - stopwatch
settings) to allow the user to view as required (ex:
L3 = LAP 3). Each time a LAP is registered the
stopwatch will ‘‘beep’’ twice as an audible indication.
-SUBTOTAL(BLOCKOFLAP)
For training purposes the stopwatch can be stopped to create subtotal or
block in two ways:
-PressandholdtheSTOPbuttonfor1s(thisisconrmedwithalong
’’beep’’).
-Remain inthe transmittereldandthestopwatch willautomatically
stop.
3 TRAINING
Chr
690
Chr
FREE
00'00''
00
L3
00'14''
43
EN 6