What to do if there is an air bubble alarm in my Fresenius Kabi Volumat MC Agilia?
If the volume of air detected in the line of your Fresenius Kabi Medical Equipment exceeds the limit, remove the air bubbles by rebooting the administration set. Also, check the air bubble size setting, calibrate, or replace the air detector.
What to do if I get an 'Administration set position alarm' on my Fresenius Kabi Medical Equipment?
If you receive an administration set position alarm on your Fresenius Kabi Medical Equipment, it might be because the pump isn't detecting the safety clamp. Check the position of the administration set and ensure the door is closed. You may also need to check the clamp detection opto and replace it if necessary.
What to do for an Administration set insertion alarm on Fresenius Kabi Volumat MC Agilia Medical Equipment?
If you're getting an administration set insertion alarm on your Fresenius Kabi Medical Equipment, begin by checking the administration set position. Also, check that the magnet is present on the door, calibrate the door sensor, or replace the door sensor.
What to do if my Fresenius Kabi Volumat MC Agilia Medical Equipment shows an OCS test failure alarm?
If your Fresenius Kabi Medical Equipment shows an OCS test failure alarm, it could be because the pumping mechanism hasn't raised the pressure in the line during the test. Try checking the administration set position. Also, verify the pressure sensor calibration, the integrity of the membrane (replacing if needed), and the installation and integrity of the administration set.
What to do if the 'Door opened' alarm appears on my Fresenius Kabi Volumat MC Agilia?
If you receive a 'Door opened' alarm on your Fresenius Kabi Medical Equipment, it might be because the Hall effect sensor detects that the door is open. Start by checking that the magnet is present on the door. Also, calibrate or replace the door sensor.
How to remove air bubble detected at start-up in Fresenius Kabi Medical Equipment?
To address an air bubble detected at start-up or in stop mode on your Fresenius Kabi Medical Equipment, remove the air bubble by priming the administration set.
General| Type | Infusion Pump |
|---|---|
| Manufacturer | Fresenius Kabi |
| Model | Volumat MC Agilia |
| Flow Rate Accuracy | ± 5% |
| Power Supply | 100-240 V AC, 50/60 Hz or rechargeable battery |
| Volume to be Infused (VTBI) | 1 ml to 9999 ml |
| Infusion Modes | Intermittent |
| Alarm System | Occlusion, Air-in-line, Low Battery, End of infusion |
| Occlusion Pressure | Adjustable |
| Bolus Rate | Adjustable |
| Battery Life | Approximately 8 hours at 5 ml/h |
| Display | LCD |
To Next Page
