04
Ensure that all packaging materials have been removed.
Before use
Never add toilet cleaner directly via the valve blade or via the
toilet bowl as this could damage the gasket ring of the waste-
holding tank. Only fill the waste-holding tank via the pour out
spout.
1. Remove the waste-holding tank through the service door.
2. Place the waste-holding tank upright and turn the pour out spout upwards. Remove the cap from
the pour out spout.
3. Add the stated dosage cleaner to the waste-holding tank, and add 2L of water to the waste-holding
tank to ensure that the bottom of the waste-holding tank is covered.
4. Screw the cap back onto the pour out spout. Slide the waste-holding tank back into its original
position via the service door.
Never use force if you cannot get the waste-holding tank back
into place easily. If blockage occurs, always check if the blade
handle is in the closed position.
+2L
To Next Page
Loading...