20
In order to flush , please turn the blade handle to make it open.
After using, please close the blade handle.
Do not use the toilet when the red light is flashing.
If you cannot solve the problem, contact the authorized local service center or Freucamp
Customer Service Office in your country.
Malfunctions
Unable to pull out the
waste-holding tank
Waste-holding tank
leaking
Unpleasant smells
1. Blade is (partially) open after
use
2. Not using Freucamp cleaner
1. Close the blade after use
2. Use Freucamp cleaner
Gasket is dry or worn out
Replace gasket
Press the flush button
but no flush-water
1.Blade (partially) not closed
2.Due to the clip of waste-holding
tank not lifted
1. When the waste-holding tank
is full, the left light on the control
panel blinks red
2. When the waste-holding tank
is removed or not in place, the
right light on the control panel
blinks red
3. When the blade is closed, the
light on the control panel is off
4. When the light on the control
panel is off, indicates the toilet
fuse is blown out
1. Empty the waste-holding tank
2. Slide the waste-holding tank
back in place
3. Move the blade handle to open
the blade
4. Replace the toilet fuse
1.Fully close the blade
2. Lift the clip, then pull out
Possible reasons Solutions
Troubleshooting
To Next Page
Loading...