Water Dispenser
Instructions for child lock lever
Press the child's lock lever with your thumb as the direction as below
① and the water lever ② will be locked to prevent children from
taking any water.
Press in the opposite direction to unlock and take water
Instructions for water tank assembly
1.Hold both sides of the tank with hands and pull the tank assembly
off the door slightly in the direction indicated as below.
Notes: The transparent silicone parts of the sealed water valve could
be brought out meantime when removing the water tank. If so, remove
them, and re-install them according to the following steps.
1-1.Align the sealed part with the hole in the door and place it in it.
1-2.It will be completed when the step of sealed part can be fitted to
the step in the hole.
2.Rotate counterclockwise to remove the water valve assembly from
the water tank for cleaning.
3.Pinch the flange of the water tank cover slightly upwards, and the
water tank cover can be separated from the water tank. Remove
the other side with the same method .The tank and its cover can
be cleaned after disassembly.
4.Install the water valve by rotating it clockwise after cleaning. When
installing the tank cover, install the one side at first (do not press it all
the way), then install the other side. Press firmly on edges of the tank
cover to fit the tank. Re-install the entire water tank assembly at 45° to
the door. Press the outer edge of the water tank slightly downwards
to make it fit into the door.
Fill the tank with pure drink water( )
*
Open the inlet cover of water tank①. Slowly fill the tank with pure
drinking water up to the maximum fill line marked with “2L”. Then
close the inlet cover①. To prevent any spills, please use a
narrow-bore container to charge water.
MAX
2L
1
MAX
2L
*
Only direct drinking water or mineral water can be stored in the
water tank
14
To Next Page
Loading...
