Intruder
-provides standard intruder monitoring with normal
ARM and PART-ARM functions.
24 Hour Intruder
- used to provide 24 hour monitoring of areas
requiring continuous security protection even while
the system is Disarmed, (e.g. gun lockers).
Activation of any detector on a security zone will
immediately initiate a Full Alarm condition.
Fire
-use to provide 24 hour monitoring of any Fire/Smoke
detectors fitted to the system. Activation of any
detector will immediately initiate a Full Alarm condition.
Test
- when the system is armed, any detector on the zone
will cause the appropriate zone LED on the Control
Panel to flash without initiating a Full Alarm condition.
Note: Personal Attack, 24 Hour Intruder and Fire
modes all operate on a 24 hour basis, (i.e. they are able
to initiate Full Alarm condition at any time irrespective of
whether the system is Armed or Disarmed).
Default setting: all zones mode 2 (Intruder).
Press , to configure zone 1
Press , to configure zone 2
Press , to configure zone 3
Press , to configure zone 4
Press , to configure zone 5
Press , to configure zone 6
The zone LED corresponding to the current operating
mode will illuminate.
Zone 1 LED Personal Attack (PA)
Zone 2 LED Intruder
Zone 3 LED 24 Hour Intruder
Zone 4 LED Fire
Zone 5 LED Test
Enter the key corresponding to the required operating
mode, the corresponding zone LED will illuminate as
the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
TELEPHONE NUMBERS
Default setting: not programmed (all numbers).
Press , to program phone number 1
Press , to program phone number 2
Press , to program phone number 3
Press , to program phone number 4
Enter the new phone number (32 digits max).
Note: Press to insert a 3.5s pause in the
number when dialled.
Press to save the new number and return to
programming mode.
Press to return to programming mode without
saving.
ALARM MESSAGE PLAY TIME
This is the total time for which the alarm messages will
be played & repeated when a call made by the voice
dialler is answered.
Default setting: 70s
Press ,
The zone LED corresponding to the current setting will
illuminate.
Zone 1 LED 50s
Zone 2 LED 70s
Zone 3 LED 90s
Zone 4 LED 110s
Enter the key corresponding to the required message
play time, the corresponding zone LED will illuminate
as the setting is changed.
Press to save the setting and return to
programming mode.
Press to return to programming mode without
saving.
23
To Next Page
Loading...
