Press the key corresponding to the required dial
method, the corresponding zone LED will illuminate as
the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
saving.
OPERATING
INSTRUCTIONS
When leaving the premises, the system must be Armed.
However, before doing so, check that all windows are
closed and locked, all protected doors are closed and
PIR Movement Detectors are not obstructed. Ensure
that pets are restricted to areas not protected by PIR
Movement Detectors.
The system has two armed modes, ARM and PART-
ARM. The Part-Arm facility allows for selected zones to
be left in a Disarmed state whilst the remainder of the
system is Armed.
When the system is Armed (in either mode) the Zone
LEDs for all active zones will illuminate for a few seconds,
in addition the appropriate Arming Mode LED will flash.
All active zones set as INSTANT will immediately be fully
Armed. If enabled the System Exit delay will start and the
Control Panel will start beeping with the beep rate
increasing in steps as the delay expires. At the end of the
Exit period all active zones set to DELAY will be fully
Armed. By this time the user must have left the property
and closed the final protected door.
If while the system is armed a detector on an INSTANT
zone is triggered then this will immediately initiate a
Full Alarm condition with both Control Panel and Siren
sounding. However if a detector on a DELAY zone is
triggered, if enabled, the Entry Delay will start and the
Control Panel will start beeping with the beep rate
increasing in steps as the delay expires. If the system
has not been Disarmed when the Entry Delay expires
a Full Alarm condition will be initiated. If a Full Alarm
condition occurs the appropriate zone LED that
triggered the alarm will flash to indicate which zone
the alarm was triggered from. If an alarm condition
occurs the zone that triggered the alarm will be
indicated by the appropriate zone LED on the Control
Panel being illuminated.
At the end of the programmed alarm duration the Siren
and Control Panel alarms will stop and the system will
automatically re-Arm itself, (subject to the conditions of
the Zone Lockout feature).
Note: The Solar Siren will shut down either after the
programmed alarm duration or after 3 minutes, if the 3
minute limit has been enabled on the Solar Siren.
ARMING THE SYSTEM
ARM
The system can be set in ARM mode using either the
Remote Control or the Control Panel as follows:
Remote Control:
Press the button,
The Control Panel will acknowledge the signal by
beeping.
Control Panel:
Press the Arm button followed by the User Access
Code and then the Enter button:
, ,
The Control Panel will acknowledge the signal by
beeping.
PART-ARM
The system can be set in PART-ARM mode using either
the Remote Control or the Control Panel as follows:
Remote Control:
Press the button,
The Control Panel will acknowledge the signal by
beeping.
Control Panel:
Press the Part-Arm button followed by the User
Access Code and then the Enter button
, ,
The Control Panel will acknowledge the signal by
beeping.
DISARMING THE SYSTEM
The system can be Disarmed using either the Remote
Control or the Control Panel as follows:
Remote Control:
Press the button,
25
To Next Page
Loading...
