FRIEDLAND SPECTRA Lite - User Manual

Lite
3
List Number L110N WHI
BEFORE STARTING ANY INSTALLATION WORK, PLEASE READ CAREFULLY
TOOLS NEEDED
● Drill and 6mm Masonry Drill Bit
● Wire cutters and Wire Strippers
● No.2 philips Screwdriver
● Terminal or Electricians Screwdriver
● Large Flat Bladed screwdriver
PARTS INCLUDED
- Bulkhead PIR light
- Instruction Manual
- Accessory pack
Instruction Manual
SAFETY
Always follow the manufacturers advice when using power tools, steps, ladders etc. and wear suitable
protective equipment (e.g. safety goggles when drilling holes). Before drilling holes in walls, check forhidden
electricity cables and water pipes, the use of a cable/pipe locater maybe advisable if in doubt.
The mains supply to this product should be installed by a competent person (e.g. a qualified electrician) in
accordance with these instructions and in accordance with the appropriate clauses of the current edition of
the IEEE wiring regulations (BS7671).
DANGER - 230 VOLTS. To prevent the risk of electrocution, always turn off the mains electricity supply
before commencing any work on the installation or opening the detector.
It is essential that all connections are made as instructed, that cables are not stressed and that terminals
are fully tightened.
Suitable for connection to fixed luminaires only. Internal and connected lamps loads must not exceed the
specified maximums. This product is suitable for wall mounting only.

Summary

Safety Precautions

Selecting a Location

Mounting, Wiring & Connection

Important Installation Safety

Switch off electricity at the fuse box before installation.

Connection Procedure

Wiring the mains supply cable to the terminal block.

Connecting Additional Light Units

How to connect extra lights controlled by the PIR detector.

Operation & Testing

Walk Testing Procedure

Step-by-step guide for testing the detector's functionality.

Setting Automatic Operation

Adjusting TIME and LUX controls for automatic night-time activation.

Masking the Sensor Lens

How to reduce sensor coverage by masking the lens.

Troubleshooting Guide

False Activation Issues

Solutions for lights staying on or random activation.

Non-Operation Issues

Troubleshooting if the detector does not operate or only operates at night/day.

Coverage and Range Problems

Addressing poor coverage or fluctuating detection ranges.

Technical Specifications

Disposal Information

Product Guarantee

Customer Helpline

FRIEDLAND SPECTRA Lite Specifications

General

Power Source (Motion Detector)	Battery
Tamper Protection	Yes
Weatherproof	No
Detection Range	12 meters
Detection Angle	110 degrees
Volume Control	Adjustable