How to operate your Friedrich
• Temp •
Fan Speed
Timer _o l/ il (_
Control and Remote Control Operations
1.POWER
Operation begins when this button ispressed
and stops when you press the button again.
2. TEMPERATURE CONTROL
The thermostat monitorsroom temperature
to maintain the desired temperature.
The thermostat can be set between
60°F~86°F (16°C~30°C).
The unit takes an average of 30 minutes to
adjust the room temperature by I°F.
3. OPERATIONMODE SELECTOR
Select cooling mode to coolthe room.
Select Money Saver@mode for energy
saving operation.
Select fan mode for basic ventilating fan
operation.
Select dry mode for dry operation.
4. FAN SPEED SELECTOR
Forincreasedpower while cooling, select a
higher fan speed.
3 steps: High; Low; Med
5. ON/OFF TIMER
The timer can be set to start and stop the
unit in hourly increments (up to 12 hours).
6. REMOTE CONTROL SENSOR
Inserting the Remote Control Batteries
1. Pushout the cover on the back
of the remote control with your
thumb
2. Payattention to polarity and
insert two newAAA 1.5V
batteries.
3. Reattach the cover.
NOTE:Donotuserechargeablebatteries.Makesurethat
bothbatteriesarenew.
• In orderto preventdischarge,removethebatteriesfrom
theremotecontrolifthe airconditionerisnotgoingto be
usedforanextendedperiodoftime
Keeptheremotecontrolawayfromextremelyhotor
humidplaces.
Tomaintainoptimaloperationofthe remotecontrol,the
remotesensorshouldnotbeexposedtodirectsunlight.
• Theremotecontrolcanbemountedon awallusingthe
mountableholder.(Friedrichdoesnotprovidethis.)
To Next Page
Loading...
Need help?
General
