31
J. STARTUP AND OPERATION
SYSTEM - The MODE button allows you to sequentially select up to four modes
of operation:
AUTO Available on select models
COOL
HEAT Available on select models
FAN ONLY
AUTO FAN (No Cooling Demand)
When in AUTO mode, the fan only operates when the system has a demand to
cool or heat the room.
In the ON fan mode, the fan operates all the time. The system periodically cools
or heats the fan’s airow but the ow of air does not stop.
UP and DOWN Arrows - Pressing either an UP or DOWN button changes the
system’s setpoint (desired room temperature). These buttons are also used to
make system parameter changes later in this manual.
One press equals 1 degree of change in Fahrenheit mode. One press equals 0.5
degree change in Celsius mode.
TIMER
The timer can be engaged or disengaged from the control panel. This is done by
pressing or holding the UP and DOWN arrows simultaneously for three seconds.
OTHER FUNCTIONS
°F – °C Select
To switch from degrees Fahrenheit (F) to Celsius (C), press the MENU button
and enter the F-C sub-menu.
FAN SPEED - Depending on your model, the FAN SPEED button allows you to
toggle between three or four modes of operation: LOW, MEDIUM, HIGH and MAX.
Alerts
When the lter needs to be cleaned or replaced, the CHECK FILTER icon
displays.
The alert can be dismissed by pressing the FAN MODE and SPEED for 3
seconds.
Lock Control Panel
To lock/ unlock the front panel controls, navigate to the “LOCK” sub-menu found af-
ter clicking the MENU button. The lock requires a four digit pass code to lock/ unlock
the unit. This pass code will be required to enter the menu to unlock the unit. The
LOCK icon illuminates to indicate the locked status.
The LOCK icon disappears to indicate unlocked status.
External Control Status
The Wi-Fi icon illuminates to indicate that the system is receiving a Wi-Fi con-
nection. The Wi-Fi icon also provides information about the signal strength.
ADVANCED FUNCTIONS
The functions mentioned in the following section may or may not be available de-
pending on the air conditioner model.
Modify the TIMER Function
Navigate to the TIME menu to set the timer.
J.3 Control Panel Operation
To Next Page
Loading...
