SETTING OVEN CONTROLS - MODELS B & C
NOTE
The oven function will not work if the time of day clock
is not set.
To Set the Clock
When the range isfirst plugged in, or when the power
supply to the appliance has been interrupted, the display
will flash "12:00".
1. Push CLOCK pad.
2. Within5 seconds,push and holdthe UP orDOWN
ARROW pad untilthe correcttime ofday appearsin
the display.
Note: The clockcannotbe changed duringany timed
bake or self-clean cycle.
To Set the Minute Timer
1. Push TIMERONIOFF pad.
2. Push the UP ARROW pad toincreasethe time
inone minuteincrements.Push and holdthe UP
ARROW pad to increasethe time in10 minute
increments.The timercan be setforany amount of
timefrom I minuteto 11 hoursand 59 minutes.
Note: Ifyou push the DOWN ARROW pad first,the
timerwilladvance to 11 hoursand 59 minutes.
3. The displayshows thetimercountdown inminutes
until one minute remains. The display will count
down in seconds.
4. When the set time has run out, the timer will beep
3 times. It will continue to beep 3 times every 60
seconds until the TIMER ON/OFF pad is pushed.
NOTE
The minute timer does not start or stop cooking. It serves
as an extra timer in the kitchen that will beep when the set
time has run out. The minute timer can be used alone or
during any of the other oven functions. When the minute
timer is in use with any other mode, the minute timer will
be shown in the display. To view other functions, push
the function pad for that mode.
To Change the Minute Timer while it is in use:
While the timer is active and shows in the display, push
and hold the UP or DOWN ARROW pad to increase or
decrease the time.
To Cancel the Minute Timer before the set time has
run out: Push TIMER ON/OFF pad.
NOTE
To turn the time of day display OFF or ON in the display
press and hold the CLOCKpad for 8 seconds (the control
will beep once) and then release. This feature does not
remove the set time of day from the memory of the
control. When the display is turned OFFthe time of day
will reappear for a few seconds any time the CLOCK
pad is touched.
To Set Control for Continuous Bake or 12
Hour Energy Saving
The oven control has a built-in 12 Hour Energy Saving
feature that will shut off the oven if the control is left on
for more than 11 hours and 59 minutes. The oven can
be programmed to override this feature for continuous
baking.
To set control for continuous baking:
I. Push and hold TIMER ONIOFF pad down for 5
seconds until tone is heard, ,,i _ hr" will appear in
display for continuous cooking. The current time of
day will return to the display.
2. To cancel the Continuous Bake Function, push
TIMER ON/OFF pad and hold for 5 seconds until
tone is heard. "12hr" will appear in display indicating
that the control has returned to the 12 Hour Energy
Saving feature.
To Set Control for Oven Lockout
The control can be programmed to lock the oven door
and inactivate the oven controls.
To Set Controlfor Oven Lockout feature:
I. Push the CLEAR OFF pad and holdfor3 seconds.
"Loc"willappear indisplay,the "DoorLocked"
indicatorlightwillflashand the motor drivendoor
lockwillbeginto closeautomatically.DO NOT open
oven door whilethe indicatorlightisflashing.Allow
about 15 secondsforthe oven door to lock.Once
the oven door islocked,the currenttime of day will
appear inthe display.
2. To cancelthe lockoutfeature,push CLEAR OFF pad
and holdfor3 seconds.The controlwillunlockthe
oven door and resume normaloperation.
NOTE
If a control pad is pressed while the Oven Door/Control
Lockout mode, "Loc" will appear in the display until
the control pad is released. But it does not disable the
clock, kitchen timer and the interior oven lights.
18
To Next Page
Loading...
