Frigidaire FHWC3025MB - Prepare the Location

8
PREPARE THE LOCATION
NOTE
Before making cutouts, make sure there is
proper clearance within the ceiling or wall.
Disconnect power.
6HOHFWDÀDWVXUIDFHIRUDVVHPEOLQJWKHUDQJHKRRG
Place covering over that surface.
Lift the range hood and set it upside down onto covered
surface.
,IFDELQHWKDVUHFHVVHGERWWRPDGGZRRG¿OOHUVWULSV
 RQHDFKVLGH,QVWDOOVFUHZVWRDWWDFK¿OOHUVWULSVLQ
locations shown.
Determine Wiring Hole Location
Determine and clearly mark a vertical centerline on
the wall and cabinet bottom.
1.
2.
3.
4.
1.
A
A Centerline
Wood filler strips
(recessed cabinet
bottoms only)
Wall
Cabinet
bottom
3” (7.6 cm)
3” (7.6 cm)
[PP
mounting screws
VENTING REQUIREMENTS
3¼´[´FP[FP9HQW6\VWHP
Vent Piece
3¼´[´FP[FP IW
90° elbow (1.5 m)
3¼´[´FP[FP IW
flat elbow (3.7 m)
3¼´[´FP[FP IW
wall cap (0.0 m)
([DPSOH9HQW6\VWHP
0D[LPXP5HFRPPHQGHG/HQJWK IWP
HOERZ IWP
IWPVWUDLJKW IWP
ZDOOFDS IWP
Length of 3¼´[´ IWP
FP[FPV\VWHP
2 ft
(0.6 m)
3¼´[´
[FP
elbow
6 ft (1.8 m)
Wall Cap