Frigidaire GPDB998JC - Page 65

B-2
SERVICE DATA SHEET
Color Code
BK......................... Black
BK-W...........Black/White
BU............................Blue
PK............................Pink
R...............................Red
R-BK...............Red/Black
R-Y................Red/Yellow
VIO.........................Violet
W...........................White
W-BK...........White/Black
:LULQJ' LDJUDP
'LVSOD\&R GHV/(''LVSOD \&RGHV5HDGRXW 
6(16,1*
:$6+,1*
5,16, 1*
'5<,1*
&/($1
237,21/('V)ODVKLQJ
67$786/('V)ODVKLQJ
----------------------Turbidity sensor is checking the condition of the wash/rinse water.
No sensing for SAVER CYCLE.
----------------------Wash portion of cycle.
----------------------- Rinsing portion of cycle.
------------------------ Drying portion of cycle.
-------------------------Shows completion of cycle. Indicator light will switch off when door is opened.
-- WASH BOOST and NO HEAT DRY LED's flashing indicates power failure has occurred. Press
START/CANCEL pad and reselect desired options and cycle.
-- The STATUS LED's that are lit when the door is opened will flash. Close door.
This information is intended for use by persons having electrical and mechanical training and a level of knowledge of these subjects generally considered acceptable in the appliance repair trade. Amana Appliances cannot be responsible, nor assume any liability, for injury or damage of any kind arising from the use of this Service Data Sheet.
Operation
LO
PF
HO
CL
'01-09'
....Low liquid in the rinse aid dispenser
.....A power failure has occurred
....Water heating delay
.....Close and latch the door
....Hour(s) delay before start
PUMP MOTOR
4.3 OHMS
THERMISTOR
10000 OHMS
@ 25 C
DRAIN MOTOR
28 OHMS
VIO
120VAC
60HZ
MEMBRANE SWITCH
ELECTRONIC CONTROL BOARD
*SOME MODELS
P6
P9
*
BU
W
DISPENSER
1928 OHMS
R-YW
P3- 1
W W
R-BK
*BLOWER
214 OHMS
W
P3- 2
VENT SYSTEM
1893 OHMS
HEATER
9.28 OHMS
W
HI-LIMIT
THERMOSTAT
*TURBIDITY
SENSOR
R
P5
WATER VALVE
699 OHMS
FLOAT
SWITCH
PK
P3- 3
W
Y Y
P1- 4 P1- 3
*RINSE AID
LEVEL SENSE
BK BK
P4- 2 P4- 1
P7
P10
P3-5
DOOR
SWITCH
W
NEUT W L1 BK
BK BK
P1-1
P8
R
P2-1
W
P2-2
BK
P2-3
W
The water/service test is a special function
initiated from the power failure mode or idle
mode.
While in power failure mode
While in idle mode
- simul taneously
press the NO HEAT DRY and START/CANCEL
pads for 1 1/2 seconds.
The dishwasher will then step through the test
cycle per the chart. Pushing the START/CANCEL
pad will advance the dishwasher to the next step.
- simultaneously press
WASH BOOST & START/CANCEL pads for
1 1/2 seconds.
Water/Service Test
000926
(
O
H
F
W
U
R
Q
L
F

6
H
U
L
H
V
3

1











$
P
D
Q
D

3

1










6
3