Surface Cooking (continued)
Ceramic Glass Cooktop (somemodels)(continued)
Operating ESEC Surface Elements (continued)
Operating the ESEC Bridge Surface Radiant Element (some models)
The cooktop isequipped with a "Bridge" surface element located at the left front and
middle positions. The Bridge can be used when cooking with rectangular (like a griddle) or
oval shaped cookware. The element will maintain an even temperature setting across both
portions of the Bridge. If needed for normal cookware, the Bridge element can work like a
single element without the Bridge.
Bridge element operation symbols are located on the control panel on each side of the
Bridge element control knob. These symbols indicate the direction to turn the control knob
when operating the Bridge element. The symbol in figure 1 indicates that only the single
portion of the Bridge element will heat (see figure 3). The symbol in figure 2 indicates
that both the single and Bridge portions of the element will heat together (see figure 4).
You may switch from either of these settings at any time during cooking with the Bridge el-
ement.
To Operate the Bridge Surface Elements:
1. Placecorrectly sized cookware on the radiant surface element.
2. Pushin and turn the surface control knob counterclockwise to heat the portion of the
Bridge element for normal shaped cookware or clockwise for larger or rectangular
shaped cookware.
3. Usethe ESECdigital display window for the desired setting. Turn the knob to adjust the
setting if needed. Start most cooking operations on a higher setting and then turn to a
lower setting to finish cooking. Eachsurface element provides a constant amount of
heat at each setting. A glowing red surface heating area extending beyond the bottom
edge of the cookware indicates the cookware is too small. Pleasenote that not all cook-
ware will fit the Bridge element correctly.
3. When cooking hascompleted, turn the surface control knob to OFFbefore removing the
cookware. Note: The HEmessage will appear after turning the control knob to OFFif
the cooktop is still hot and will remain on until heating surface area has cooled suffi-
ciently.
The BRIDGEelement may also be used in combination with the left rear single element
(see figure 5). Becausethese element have 2 different controls, one element can be used
to cook while the other element may be used to keep food warm.
Radiant surface elements may appear to have cooled after they have been
turned off. The glass surface may still be hot and burns may occur if the glass surface is
touched before it has cooled sufficiently.
Figure 1
Figure 2
Appearance and graphics of
cooktops may be differents
i _ i k i J
i i
i ii ii i
i i i
Figure 3
ii
Figure 4
Figure 5
14
To Next Page
Loading...
