Frigidaire PLCS389DCB - Before You Call; Solutions to Common Problems; Self-cleaning cycle does not work.

Before You Ca[[
SoButions to Common ProbBems
OCCURENCE POSSIBLE CAUSE/SOLUTION
Flames inside oven or smoking from
vent.
Excessivespillovers in oven. Set self<lean cycle for a longer cleaning time.
Excessivespillovers in oven. This is normal, especially for pie spillovers or large
amounts of grease on the oven bottom. Wipe up excessive spillovers before
starting the self<lean cycle. If flames or excessive smoke are present, stop the
self<lean cycle and follow the steps under "Stopping or Interrupting the Self-
Cleaning Cycle" in the Electronic Oven Control guide.
Oven smokes excessively during
broiling.
Control(s) not set properly. Follow instructions under Setting Oven Controls guide.
Make sure oven is opened to Broil Stop Position.
Meat too close to the element. Reposition the rack to provide proper clearance
between the meat and the element. Preheat broil element. Preheat broil element
for searing.
Grid on broiler pan wrong side up and grease not draining. Always place grid on
the broiler pan with ribs up and slots down to allow grease to drip into pan.
Grease has built up on oven surfaces. Regular cleaning is necessary when broiling
frequently. Old grease or food spatters cause excessivesmoking.
Self-cleaning cycle does not work,
Control(s) not set properly. Follow instructions under Oven Cleaning in the
Electronic Oven Control guide.
Self<leaning cycle was interrupted. Stop time must be 3 to 4 hours past the start
time. Follow steps under "Stopping or Interrupting tile Self-Cleaning Cycle" in the
Electronic Oven Control guide.
Soil not completely removed after
serf-cleaning cycle.
Failure to (:lean bottom, front top or oven, frame or door area outside oven seal.
These areas are not in the self<leaning area, but get hot enough to burn on
residue. Clean these areas before the self<leaning cycle isstarted. Burned-on
residue can be cleaned with a stiff nylon brush and water or nylon scrubber. Be
careful not to damage the oven seal.
Avoid Transportation Damage to your Range
If you have to move your range into/out of your residence or when moving to a new home, it is suggested that you take the
following precautions:
1. Screw in the levelling legs under tile range.
2. Remove the racks and other utensils from the oven, and from the lower drawer.
3. Use adhesive tape to firmly secure the door and the drawer to tile side panels. Also attach the electric power cord in the
same manner
4. Use a two-wheeled trolley with strap and fasten the range to it. Cover the appliance with a heavy blanket to prevent
scratches and dents,
5. Avoid pulling or pushing the control panel when moving the appliance.
24