IMPORTANT SAFETY iNSTRUCTIONS (continued)
IMPORTANT INSTRUCTIONS FOR CLEANING
YOUR RANGE
• Clean the appliance regularly to keep all parts free of
grease that could catch fire. Exhaust fan ventilation hoods
and greasefilters should be kept (:lean. Do not allow grease
to accumulate. Greasy deposits in the fan could catch fire.
Refer to the hood manufacturer's instructions for cleaning.
Cleaners/aerosols--Always follow the manufacturer's rec-
ommended directions for use. Beaware that excessresidue
from cleaners and aerosols may ignite causing damage and/
or injury.
Do not use oven cleaners. No oven cleaner or oven liner
protective coating of any kind should be used in or around
any part of tile oven.
Remove oven racks. Oven racks color will change if left in
the oven during a self-cleaning cycle.
The health of some birds is extremely
sensitive to the fumes given off during the self-clean
cycle of any range. Move birds to another wett venti-
lated room.
IMPORTANT SAFETY NOTICE
SELFoCLEANING OVENS
• Clean in the serf-cleaning cycle only the parts of the
oven listed in this owner's guide. Before self-cleaning
the oven, remove the broiler pan and any utensils stored in
the oven.
The California Safe Drinking Water and Toxic: Enforcement
Act requires the Governor of California to publish a list of
substances known to the state to cause cancer, birth defects
or other reproductive harm, and requires businesses to warn
customers of potential exposure to such substances.
• Do not clean the oven door gasket. The door gasket is
essential for a good seal. Care should be taken not to rub,
damage or move the gasket.
SAVE THESE INSTRUCTIONS
Liquefied Petroleum (Propane) Gas Conversion
The cooktop can be used with Natural Gas or Propane Gas. It isshipped from the factory for use with natural gas.
If you wish to convert your appliance for use with LP/Propane gas, use the supplied fixed orifices located in a bag containing the
literature marked, "FOR LP/PROPANEGAS CONVERSION". Follow the instructions package with the orifices.
The conversion must be performed by a qualified service technician in accordance with the manufacturer's instructions and all
codes and requirements of the authority having jurisdiction. Failureto follow instructions could result in serious injury or property
damage. The qualified agency performing this work assumes responsibility for the conversion.
Severeshock or damage to the appliance may occur if the appliance is not installed by a qualified installer.
To Next Page
Loading...
Need help?
General
