15
SETTING MAIN OVEN CONTROLS
SETTING SILENT CONTROL OPERATION
The DELAY START and SELF CLEAN pads control
the Silent Control operation feature. The Silent Control
operation feature allows the oven control to be operated
without sounds or beeps whenever necessary. If desired
the control can be programmed for silent operation and
later returned to operating with all the normal sounds
and beeps.
1. To tell if your range is set for normal or silent
operation press and hold Delay start for 7 seconds.
“” will appear and “DELAY” will ash in the
display. After 7 seconds “SP” or “” will appear in
the display.
2. Press Self clean to switch between normal sound
operation and silent operation mode. The display will
show either “SP” or “”. Note: If “SP” appears, the
control will operate with normal sounds and beeps.
If “” appears, the control is in the silent operation
mode.
3. Press Start to accept the change or press Cancel to
reject the change.
Note: The control will always beep at the end of a
minute timer and will beep when a set temperature
has been reached, even if the control is set to silent
operation.
SETTING TEMPERATURE DISPLAY —
FAHRENHEIT OR CELSIUS:
Theand Self clean pads control the Fahrenheit or
Celsius temperature display modes. The oven control can
be programmed to display temperatures in Fahrenheit
or Celsius. The oven has been preset at the factory to
display in Fahrenheit.
Celsius to Fahrenheit
1. To tell if the display is set for Fahrenheit or Celsius
press and hold it for 7 seconds; “” will
appear and will ash in the display and a
beep will sound. If “F” appears, the display is set to
show temperatures in Fahrenheit. If “C” appears, the
display is set to show temperatures in Celsius.
2. Press Self clean to switch between Fahrenheit or
Celsius display modes. The display will show either
“F” or “C”.
3. Press Start to accept the change or press Cancel to
reject the change.
SETTING MINUTE TIMER
The Timer on
.
off pad controls the Minute Timer feature.
The Minute Timer serves as an extra timer in the kitchen
that will beep when the set time has run out. It does
not start or stop cooking. The Minute Timer feature can
be used during any of the other oven control functions.
Refer to “Minimum and Maximum Control Pad Settings”
for time amount settings.
To set the Minute Timer (example for 5 minutes)
1. Press Timer on
.
off. “” will appear and “Timer”
will ash in the display.
2. Press the number pads to set the desired time in the
display.
3. Press Start. The time will begin to count down with
“” and “TIMER” will stay in the display. Note: If
Start is not pressed the timer will return to the time
of day after 25 seconds.
4. When the set time has run out, “End” and “TIMER”
will show in the display. The clock will sound with 3
beeps every 5 seconds until Timer on
.
off is pressed.
To cancel the Minute Timer before the set time has
run out
1. Press Timer on
.
off. The display will return to the time
of day.
SETTING LOCKOUT FEATURE
The pad controls the Lockout feature. The Lockout
feature automatically locks the oven door and prevents
the oven from being turned ON. It does not disable the
clock, Minute Timer or the interior oven lights.
1. Press and hold
for 3 seconds.
2. After 3 seconds a beep will sound, “Loc” will appear
and “DOOR LOCKED” will ash in the display.
Once the oven door is locked the “DOOR LOCKED”
indicator will stop ashing.
1. Press and hold
for 3 seconds. A beep will
sound. “LOC” will disappear. The “DOOR LOCKED”
will ash in the display until the oven door has
completely unlocked.
2. The oven is again fully operational.
To Next Page
Loading...
