ENG
17
10. Care & cleaning
Prior to any cleaning (inside or outside the device) procedure,
unplug the ICM! Remove the plug and make sure that the
operator can check from any of the points which he has access
that the cable is unplugged.
Never use a water hose or high pressure jet to clean the cooler.
It is important to clean the merchandiser at least twice a year. In order to avoid mold formation,
odours, etc. product compartments must be thoroughly cleaned. The interior of the ICM should be
cleaned with a mildly soapy cloth and the glass surface using a window-cleaning agent.
In case the merchandiser is placed in very dusty and/or greasy
environment, the regular cleaning of the condenser by an
authorised technician is mandatory.
Keep the cooler in a stable position during cleaning, do not step
on or lean over the cooler.
Do not clean with sharp objects, flammable or corrosive liquids
or sprays.
11. Troubleshooting
All access to the cooling system and electrical parts (changing lighting or
refrigeration deck) must be performed by authorised personnel only.
Models Smart-300 [R290], Smart-450L [R290], Smart-450L SZ T
[R290], Smart-800 [R290], Smart-900L SD [R290], Smart-900L HD
[R290], Smart-1300 HD [R290] and Smart-1300 SD [R290] are
equipped with HC refrigerant. All service operations on cooling
mechanism & gas charging should be performed in a well-
ventilated environment or in open air. Do not smoke during
maintenance.
UNPLUG THE COOLER PRIOR TO ANY MAINTENANCE OR SERVICE
OPERATIONS. REMOVE THE PLUG AND MAKE SURE THAT THE
OPERATOR CAN CHECK FROM ANY OF THE POINTS WHICH HE
HAS ACCESS THAT THE CABLE IS UNPLUGGED.
After maintenance operations, make sure that the grounding
connections are in place before assembling the covers. Make sure
you use the same fastening components and covers.
To Next Page
Loading...
