1 STANDARDS AND GENERAL WARNINGS
M-7.3-16 Rev. 05 09/03/15 BLOOD BANK REFRIGERATORS AND PLASMA FREEZER 8
Use and maintenance manual
1.3 PRODUCT DESCRIPTION
The appliance comprises a single body with panelling in various materials and insulation in
expanded polyurethane foam density. The appliance instruments are located on the front panel
where the electrical wiring is housed. The motor unit and the condenser unit can be housed either
on the top or on the bottom closed by a frontal panel and a rear grid. The interior parts are fitted
with suitable supports for drawers and other accessories. Glass doors are fitted with an automatic
return device and magnetic seal elements. During the design and construction stage all measures
have been adopted to implement total safety including radius interior corners, funnel-shaped base
panel to convey condensate to exterior, no rough surfaces, fixed guards protecting moving or
potentially dangerous parts.
1.4 GENERAL SAFETY REGULATIONS
Read this manual carefully and follow the prescriptions contained herein.
The user assumes full responsibility in case of operations carried out without observing the
instructions in the manual. None of FRI.MED products are designed to work in presence of
flammable gases or solvent that may easily burn, hence keep off the unit of any of these
situations.
Primary general safety regulations:
Do not touch the unit with wet hands and/or feet
Do not use the appliance with bare feet
Do not insert screwdrivers or other pointed objects between guards or moving parts of the
appliance
Do not pull the power cord to disconnect the appliance from the electrical mains
Make sure that the appliance is not used by unsuitably qualified persons
Before performing any cleaning or maintenance on the appliance disconnect it from the
electrical mains by switching off the main switch and extracting the plug
In case of faults or malfunctions, switch off the appliance and do not attempt to repair it by
yourself. All service and repair operations must be performed exclusively by a suitable
authorized engineer.
This symbol on the equipment indicates a situation of danger. Pay attention
and read carefully what it refers to
1.5 CLIENT’S RESPONSIBILITIES
The customer is required to:
Execute the electrical connection of the appliance
Prepare the place of installation
Provide consumable materials for cleaning
Perform routine maintenance
In the case of power failures or malfunctions do not open the doors in order to maintain as much
as possible the internal temperature. If the problem persists for more than few hours, move the
contents to a more suitable place.
1.6 CLIENT SERVICE REQUESTS
For all technical problems and any requests for technical service, refer exclusively to your local
dealer, pointing out model and serial number.
To Next Page
Loading...
