Establishing a Connection Using WPS
FRITZ!WLAN Repeater 310 11
Connecting FRITZ!WLAN Repeater via WPS with
FRITZ!Box
This section describes how to connect the
FRITZ!WLAN Repeater with a FRITZ!Box using WPS.
You can also connect the FRITZ!WLAN Repeater with any other
WLAN base station that supports WPS as described below. In
this case, please also take note of the instruction in the docu-
mentation of your WLAN base station.
1. Connect the FRITZ!WLAN Repeater to an electrical outlet
in the vicinity of the FRITZ!Box.
2. Press the “WPS” button on the FRITZ!WLAN Repeater.
Hold the button down until the “WLAN” LED begins
flashing. This takes about 6 seconds.
To Next Page
Loading...
