Fritz! WLAN Repeater - Low WLAN N Throughput; Network Connectivity Problems; Firewall and IP Configuration Issues

FRITZ!WLAN Repeater 310 26
Throughput Too Slow for WLAN N
6.5 Throughput Too Slow for WLAN N
A WLAN device (for instance, a computer) connected with the
FRITZ!WLAN Repeater should use the 802.11n (WLAN N)
standard for high data transmission speeds. The throughput
achieved by this device is too low for WLAN N.
In the FRITZ!WLAN Repeater, in the WLAN base station, or in
both devices, an encryption method other than WPA2 has
been configured.
The 802.11n WLAN standard can be used only with the en-
cryption method WPA2. Set the WLAN base station and the
FRITZ!WLAN Repeater to WPA2.
You can also use the 802.11n WLAN standard in non-encrypt-
ed (open) WLAN networks. However, an open WLAN radio
network is a security risk. Therefore we strongly recommend
encrypting all WLAN radio networks!
6.6 Cannot Access Devices in the Network
No other devices in the network can be accessed.
A firewall is running on the devices.
Configure the firewall to allow access to the network.
The devices are not configured to receive their IP addresses
automatically.
Set up the devices as directed in the section Obtaining an IP
Address Automatically from page 27.
Cause
Help
Cause
Help
Cause
Help