Cannot Access Devices in the Network
FRITZ!WLAN Repeater 310 27
The devices are not bound to TCP/IP.
Check the network connection of the network adapter in the
device in question. See the documentation of your operating
system for more information.
Obtaining an IP Address Automatically
This section describes how to set automatic IP address as-
signment in the computers in the network.
Obtaining an IP Address Automatically in Windows
1. Open the network connections:
Windows 7 and Windows Vista: Click “Start”, enter
“ncpa.cpl” in the search line of the start menu, and
press “Enter”.
Windows XP: Select “Start / Run”, enter “ncpa.cpl” and
then click “OK”.
Entering “ncpa.cpl” in Windows 7
2. Click the network connection of the computer with the
right mouse button and select “Properties”.
Windows 7 and Windows Vista: Under “This connection
uses the following items”, select “Internet Protocol Ver-
sion 4 (TCP/IPv4)”.
Windows XP: Under “This connection uses the following
items”, select “Internet Protocol (TCP/IP)”.
3. Click the “Properties” button.
Cause
Help
To Next Page
Loading...
